Yokogawa 414 Batch Controller - Manual (Page 33)

Calibration 31
On first entering the Calibration routine, the display will show:
CAL Setup Program parameters (see Section 5.1)
Batch Enter Batch parameters (see Section 5.2)
Option Option - if installed (see Section 5.3)
Test Check Input Signals (see Section 5.4)
End Exit to Normal Operation
The user can toggle between these modes using the DISPLAY switch and by using
the STOP switch, select the appropriate mode.
To exit Calibration, step through the Setup program, Batch program or Test
program until the end, and press the STOP switch when End is displayed, (ensure
the calibration link is not connected).