Yokogawa 414 Batch Controller - Manual (Page 40)

38 Calibration
5.4 CHECKING THE INPUT SIGNAL
Step Display Description Text
Ref
1 TEST
OPTIONS
CAL
BATCH
END Check the Input Signals.
Options (if installed).
Program Setup Parameters.
Set Batch Parameters.
Exit to normal operation.
5.3
5.1
5.2
The following steps are displayed if TEST is selected.
2 Sr x.xx Software revision number.
3 Freq
xxxx.x
Displayed for 1 second followed by the actual
frequency.
Frequency in Hz.
If the RS232/422/485 option is installed, the display will then show:
4 CLOC
xx:xx:xx Clock.
Time in Hours:Mins:Sec.