Yokogawa 414 Batch Controller - Manual (Page 19)

Operation 17
3.2.4 Auto Restart
The Batch Controller can be programmed to continually repeat the batch process.
This mode of operation is selected during the programming procedure.
The process is started by pressing the RUN key whereby the normal batch
operation is commenced. After reaching the End of Batch (see Section 3.2.3), the
Batch Controller will then wait for a pre-programmed period before automatically
resetting and starting the batch process once again.
The STOP button can be pressed at any time to interrupt the batching process and
continued using the RUN key. If, however, the process is to be aborted, the STOP
key is again pressed. The Batch Controller is reset and to restart the auto batching
process the RUN key is pressed.