Yokogawa Multi Channel Oxygen Analyzer System ZR22/AV550G - Manual (Page 44)

<6. IN-PROCESS OPERATION>
6-3
IM 11M12D01-61E
When Simulate En/Disable in Table 6.3 above is set to “Active”, the applicable function block uses
the simulation value set in this parameter instead of the data from the transducer block. This setting
can be used for propagation of the status to the trailing blocks, generation of a process alarm, and as
an operation test for trailing
Figure 6.1 SIMULATE_ENABLE Switch Position
O
N
1
2
F0602.ai
Set to OFF during
normal operation.
Not used.