Yokogawa Low Concentration (ppm) Zirconia Oxygen Analyzer OX400 User Manual
User’s manual
Advertising
Table of contents
Document Outline
- INTRODUCTION
- 1. Outline
- 2. Specifications
- 3. Installation
- 4. Piping and Wiring
- 5. Names and Functions
- 6. Operation and Parameters
- 6.1 Startup and Settings
- 6.1.1 Setting Output Range “rnG”
- 6.1.2 Setting Secondary Output “oUt2”
- 6.1.3 Setting HOLD Function “HoLd”
- 6.1.4 Setting Burnout Function “nAMU”
- 6.1.5 Setting Alarms (Oxygen Concentration High/Low Alarms) “ALM”
- 6.1.6 Setting Calibration Gas Concentration “SEt.C”
- 6.1.7 Setting Sensor Constant “SEnS”
- 6.1.8 Setting Output Smoothing “SMoo”
- 6.1.9 Setting Multi-Selector “MLS”
- 6.1.10 Checking Calibration Coefficient “CoEF”
- 6.1.11 Displaying Cell Resistance Value “CEL.r”
- 6.1.12 Displaying Software Revision “rEV”
- 6.1.2 Setting Secondary Output “oUt2”
- 6.2 Calibration “CAL”
- 6.3 Communication
- 6.4 Measurement Gas Sampling Using Aspirator
- 6.5 Switching Measurement Flow Path Using Multi-Selector
- 6.6 Numerical Value, Decimal Point, and Unit Input Operation
- 6.1.1 Setting Output Range “rnG”
- 6.1 Startup and Settings
- 7. Inspection and Maintenance
- 8. Appendix
- CMPL
- Revision Information