AMX Modero NXT-1200V - Manual (Page 29)

Touch Panel Accessories
17 NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
5. While maintaining the 25° angle alignment on the new module, push it in firmly until the contact pins are
completely inside the connector and the card "snaps" into place (FIG. 20).
6. Push the card downward (to the main board) until the side braces snap atop the NXA-PCI80211G and
hold it in place.
7. Locate the terminal ends of the antennas and apply downward pressure to "snap" them onto their gold-
tipped counterparts on the mini-PCI card (FIG. 20). Carefully push down on each connector to verify it is
securely joined to the card.
Step 3: Install the Compact Flash Memory Card upgrade
1. Discharge any static electricity from your body by touching a grounded metal object and then locate the
existing Compact Flash card (factory-shipped with 128 MB) on the main board (FIG. 21 for Table Top
panels and FIG. 24 for Wall Mount panels).
FIG. 19 Location of the mini-PCI card connector on main board
FIG. 20 Installation of the mini-PCI card connector on main board
Connection point
between the braces and
the mini-PCI card
Antennas connectors
It is recommended that any upgrade of internal equipment be done simultaneously in
order to reduce the risk of damage to internal components.