Upgrading the modero firmware via an ip address, Fig. 75). v, In fig. 75) – AMX Modero NXT-1200V User Manual
Page 88
Upgrading Modero Firmware
76
NXD/T-1200V 12" Modero® Video Wall/Flush Mount Touch Panel
8.
Select the panel’s Kit file from the Files section.
9.
Enter the Device value associated with the panel and the System number associated with the Master
(listed in the OnLine Tree tab of the Workspace window). The Port field is greyed-out.
10.
Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update
process is complete. The reboot of the panel can take up 30 seconds after the firmware process has
finished.
11.
Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog
(B in FIG. 75).
12.
As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has
completely restarted.
13.
Reconnect the USB connector to the panel.
14.
Right-click the associated System number and select Refresh System. This causes a refresh of all project
systems, establishes a new connection to the Master, and populates the System list with devices on your
particular system.
15.
Confirm the panel has been properly updated to the correct firmware version.
Upgrading the Modero Firmware via an IP Address
Before beginning with this section, verify that your panel is powered and connected to the NetLinx Master
through an Ethernet connection (direct or wireless).
Step 1: Prepare the Master for communication via an IP
1.
Obtain the IP Address of the NetLinx Master from your System Administrator. If you do not have an IP
Address for the Master, refer to your particular Master’s instruction manual for more information on
obtaining this IP Address using NetLinx Studio 2.
From the Online Tree tab of the Workspace window, select the NetLinx Master.
Follow steps outlined in either the Obtaining or Assigning the Master’s IP Address sections from
your particular NetLinx Master instruction manual to use an address.
Note the IP Address and Gateway information.
2.
Launch NetLinx Studio 2.x (default location is Start > Programs > AMX Control Disc > NetLinx
Studio 2 > NetLinx Studio 2).
FIG. 75
Using USB for a Virtual Master transfer
A
B