Renkus-Heinz ICL-R - Manual (Page 19)

IC L ive Users Manual - Models ICL-R & IC215S-R
19
Load Preset
The Load Preset control and its associated up/down arrows are used to select and install (load) a specific Preset into the array’s DSP
memory.
If no DSP data is included in the Preset, a dialog box will call the lack of DSP data to your attention and ask if it is OK to proceed.
Answering Yes, will initiate the process, introduce a Loading Status screen and hide the lettering in the Beams / Presets window. The Load-
ing Status window will disappear and the lettering will reappear when the process is complete.
Controls
Most of the buttons at the bottom of the window provide additional control over Presets.
The Panel Controls serve different functions. Clicking on the Panel Display control will turn the Preset digital readout display on the rear of
the array On and Off. The display is often turned off during a performance to prevent the readout’s red glow from being a distraction. The
button will say On in red when the readout is turned On. Note that the digital readout can also be turned On and Off using the Preset Up
and Preset Down push buttons on the array’s control panel. Pressing both of these controls at the same time toggles the readout between
On and Off.
The Panel Buttons control locks all the controls on
the rear of the associated array to prevent inadvertent
changing of the settings or tampering. The padlock
icon will be closed when the controls are locked.
SysTune Interface
If you are using SysTune as your measurement
system during setup and tuning, you can access the
array’s DSP from within SysTune.
This allows you to take a measurement, adjust the
EQ settings and then view the result of the changes in
real time within one program and on one screen - - no
more jumping back and forth between programs and
windows.