Renkus-Heinz ICL-R - Manual (Page 68)

IC L ive Users Manual - Models ICL-R & IC215S-R
68
Sensitivity:
Freq. Range:
Max SPL:
№. Transducers:
Dimensions:
Weight:
Hardware:
Enclosure:
Inputs:
Controls (Rear Mounted):
Computer Controls:
Status Indicators:
Power Connector:
Finish:
Network Digital Format:
PM-2LR AMPLIFIER
Type:
Power Rating:
THD Distortion:
Hum & Noise
:Power Required:
1.4 V (for rated power output)
43 Hz to 100 Hz
136 dB peak,
Two model SSL15-14, 15” cone woofers, 800 Watts
program at 4 Ohms (each)
44.5” H x 20” W x 24” D (113 cm x 50.8 cm x 61 cm)
206 Lbs (93.4 Kg)
Aeroquip Flytrack, Handles, Casters
Finnish Birch, perforated steel grille
Analog Audio Input 1: Looping XLR (female in, male out)
Analog Audio Input 2: Phoenix 6-pin (looping 3-in, 3-out)
CobraNet: Dual RJ45 connectors (for CAT 5 copper cable)
AES/EBU: Phoenix connector
Power On/Off, Push-To-Reset circuit breakers
Mute button;
Up & Down Output Level push buttons;
10 dB Input pad (on Analog 1 input)
Gain, Mute, On/Standby, Input Selection
Compression,
8-Band Parametric EQ
Shelving & Rolloff Filters
Delay
Power, Signal, Overdrive, Thermal, Mute, Input Pad
Powercon locking connector
Black paint
16, 20 or 24 bit PCM; 48 or 96 kHz sample rat;
Selectable network latency
Class D amplifier/DSP processor
2 x 850 Watts RMS, 950 W Program
< 0.05% typical
<100 dB (A weighted)
90/136 V or 180/260 V AC, 50/60Hz.
13 Amps @ 120 V; 6.5 Amps at 240 V
Idle current; 380 ma @ 120 V; 190 ma @ 240 V
Note: All analog inputs and outputs comply with AES Standard 45-2005 on interconnecting,grounding and shielding.
IC215S-R Technical Specifications