Renkus-Heinz ICL-R - Manual (Page 66)

IC L ive Users Manual - Models ICL-R & IC215S-R
66
Sensitivity:
Freq. Range:
Max SPL:
Horiz. Dispersion:
Vert. Opening Angles:
Aiming Angle:
Typical Throw:
Beam Control:
№. Transducers:
(per module)
№. Amp. Channels:
Dimensions:
Weight:
Hanging Method:
Enclosure:
Inputs:
Controls (Rear Mounted):
Computer Controls:
Status Indicators:
Power Connector:
Finish:
Network Digital Format:
DSP/AMPLIFIER
Type:
Input Impedance:
M ax Input:
Power Rating:
Freq. Range:
THD Distortion:
Hum & Noise:
Power Required:
(per module)
01.0 V (for rated power output)
80 Hz to 20 kHz
105 dB peak @ 100 Ft. (30.5 meters),
108 dB peak when stacked
(3-octave bandwidth centered at 2 kHz)
150° up to 3 kHz; 120° above 3 kHz
20°, 25° and 30° (5°, 10°, 15° and 20° when stacked)
Adjustable from -30° to +30°
66 Ft. (20 m) 132 Ft. (40 m) when stacked
Effective down to 800 Hz (400 Hz when stacked)
Five 6.5-inch cone transducers with neodymium magnets
Three 1-inch HF titanium nitride compression drivers
8 (per module)
48” H x 8” W x 11.3” D (121.5 cm x 20. cm x 28.7 cm)
61 Lbs (27.7 Kg)
AeroQuip Fly-Track
Finnish Birch with Aluminum end caps and
perforated steel grille; suitable for outdoor use
Analog Audio - AES/EBU Inputs: Looping XLR (female in, male out)
and Phoenix 6-pin (looping 3-in, 3-out)
CobraNet: Dual RJ45 connectors (for CAT 5)
Mute button; Up & Down Output Level push buttons; 10 dB Input pad (on Analog 1
input),Power On/Off,; Push-To-Reset circuit breaker; Configuration PreSet Selector
Gain; Mute; On/Standby, Input Selection; Compression, 8-Band Parametric EQ,
Shelving & Rolloff Filters; Delay, Configuration Preset Readout
Power, Signal, Overdrive, Thermal, Mute, Input Pad, Failure, Preset Configuiration
Powercon locking connector
Black paint
16, 20 or 24 bit PCM; 48 or 96 kHz sample rate; selectable network latency
8-channel, Class D amplifier/DSP processor
>20K Ohm balanced differential
+24 dBu (Pad in 0; +14 dBu @ 1V sensitivity (Pad out)
100 Watts RMS per channel, 150 Watts Burst
+ 3, - 3 dB, 80 Hz to 20 kHz
< 0.05% typical
<100 dB (A weighted)
Universal 90/260 VAC, 50/60Hz.
500 VA @ Rated Power Output; 29 VA Idle;
(4.2 Amps @ RPO at 120 V; 250 ma Idle)
ICL-R Technical Specifications
Note: All analog inputs and outputs comply with AES Standard 48-2005 on interconnecting, grounding and shielding.