Renkus-Heinz ICL-R - Manual (Page 32)

IC L ive Users Manual - Models ICL-R & IC215S-R
32
Before going on you should first verify
that the correct measurement system is
being used (feet or meters). The default
measurement system is feet but you may
want to use meters.
To check or change the setting, select
Preferences from the Options pull down
menu in the tool bar section of RHAON
or right click in the center of the beam
steering window. The Preferences folder
will open in the Genaral Tab view
If you want to change from feet to meters,
check the Metric radio button.
Note that this window also allows you to
control the behavior of the Fault Relay
and the Power-On sequencing delay.
The Beam Steering tab contains the
setting controls for the appearance of
the Beam Steering window. The normal
default setting are shown.
Notice that this setup window also allows
you to change the height of the measur-
ing plane (the Ear Height). Until you are
more familiar with the program we
suggest you accept the default setting.
There are times, however, when you will
want to change the height of the mea-
suring plane. It is set to 1.2 meters (3.94
feet) which is fine for a seated audience,
but not for a standing audience. For a
standing audience a height of 5.5 feet is
commonly used.
The Mapping Appearance section allows
you to control the appearance of the
main Mapping plot. For now, we sug-
gest using the default settings. You can
experiment with various settings later.
The Scale Level Views section gives
you control over the scales used in the
main Mapping window. Many experi-
enced users like to use the Fixed Range
option under Scale Level Views; setting
the Round Up to 5 and the Show Range
to 5. You may want to experiment with
this to see which settings you like best.
We’ll investigate the other tabs later.