Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 553)

Unified IP MIB Reference 525
53-1002549-02
OSPF area status table
OSPF area status table
The OSPF area status data structure contains information regarding the configured parameters
and cumulative statistics of the router’s attached areas. The interfaces and virtual links are
configured as part of these areas. Area 0.0.0.0 is the Backbone Area.
Reference: RFC 1583 “OSPF Version 2”, section 6 The Area Data Structure.
NOTE
The following table is not supported on the Brocade MLXe router, Brocade NetIron XMR, Brocade
NetIron MLX, Brocade NetIron CES, and Brocade NetIron CER seriesR devices.
snOspfExtLsdbChecksum
brcdIp.1.2.4.10.1.1.7
Syntax: Integer32 Read-only Indicates the checksum for the LSA packet. The checksum is based
on all the fields in the packet except the age field. The Layer 3 Switch
uses the checksum to verify that the packet is not corrupted.
snOspfExtLsdbAdvertisem
ent
brcdIp.1.2.4.10.1.1.8
Syntax: OCTET STRING Read-only Shows the data in the link-state advertisement, including its header in
octets. There can be up to 36 octets in this object.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snOspfAreaStatusTable
brcdIp.1.2.4.11.1 None The OSPF area status table.
snOspfAreaStatusEntryIndex
brcdIp.1.2.4.11.1.1.1
Syntax: Integer32 Read-only The ID of an entry in the OSPF area status table.
snOspfAreaStatusAreaId
brcdIp.1.2.4.11.1.1.2
Syntax: AreaID Read-only Specifies the ID of an area. The format of this 32-bit integer is
determined by the value of the
“snOspfAreaStatusAreaIdFormat”
object.
Area ID 0.0.0.0 is used for the OSPF backbone.
snOspfAreaStatusImportASExtern
brcdIp.1.2.4.11.1.1.3
Syntax: Integer32 Read-only The area’s support for importing AS external link-state
advertisements.
Default: 1
snOspfAreaStatusStubMetric
brcdIp.1.2.4.11.1.1.4
Syntax: BigMetric Read-only The metric value applied at the default type of service
(ospfMetric). By default, this equals the least metric at the type
of service among the interfaces to other areas. This object exists
only if the value of snOspfAreaSummary is
snOspfAreaSummary(2); otherwise, an SNMP_GET or GET_NEXT
attempt of this object will return NO_SUCH_NAME.
snOspfAreaStatusSpfRuns
brcdIp.1.2.4.11.1.1.5
Syntax: Counter32 Read-only Shows the number of times that the intra-area route table has
been recalculated using this area’s link-state database.
snOspfAreaStatusAreaBdrRtrCou
nt
brcdIp.1.2.4.11.1.1.6
Syntax: Gauge32 Read-only Shows the number of area border routers that are reachable
within this area. This is initially zero, the default, and is
calculated in each shortest path first (SPF) pass.