Brocade Unified IP MIB Reference (Supporting FastIron Release 07.5.00) - Manual (Page 695)

Unified IP MIB Reference 667
53-1002549-02
Virtual server port history table
Virtual server port history table
The virtual server port history table contains history data samples for each port on the virtual
server.
snL4VirtualServerPortHistoryCont
rolInterval
brcdIp.1.1.4.28.7.1.5
Syntax: Integer Read-write Shows the interval, in seconds, over which the data is sampled
for each bucket.
NOTE: A counter for a bucket may overflow without any
indication; thus, be sure to account for the overflow in
all the counters you configure. Consider the minimum
time it takes for a counter to overflow and set this object
(snL4VirtualServerPortHistoryControlInterval) to a value
less than the overflow interval. This is especially
important for the “octets” counter in any data-source
table.
You cannot modify the value of this object if the value of this
entry’s
“snL4VirtualServerPortHistoryControlStatus” object is
equal to valid(1).
Valid values: 1 – 3600 seconds
Default: 1800 seconds
snL4VirtualServerPortHistoryCont
rolOwner
brcdIp.1.1.4.28.7.1.6
Syntax: DisplayString Read-write The administrator who owns or configured this entry.
snL4VirtualServerPortHistoryCont
rolStatus
brcdIp.1.1.4.28.7.1.7
Syntax: Integer Read-write The state of this entry:
•
valid(1)
•
createRequest(2)
•
underCreation(3)
•
invalid(4) – This entry will be deleted from the table if its
state changes to this state.
Name, OID, and syntax Access Description
Name, OID, and syntax Access Description
snL4VirtualServerPortHistoryTable
brcdIp.1.1.4.28.8 None Virtual server port history table.
snL4VirtualServerPortHistoryIndex
brcdIp.1.1.4.28.8.1.1
Syntax: Integer Read-only Shows the index entry as identified by
“snL4VirtualServerPortHistoryControlIndex” .
snL4VirtualServerPortHistorySam
pleIndex
brcdIp.1.1.4.28.8.1.2
Syntax: Integer Read-only An index that uniquely identifies this particular sample among
all samples associated with the same entry. This index starts at
1 and increases by one as each new sample is taken. There can
be up to 2,147,483,647 samples.