Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 28)

Blade Port numbering Trunking port groups
FC8-32E port
blade • 0 through 15 from bottom to top on the
left set of ports.
• 16 through 31 from bottom to top on the
right set of ports.
• 0-7, 8-15, 16-23, and 24-31
FC8-48E port
blade • 0 through 23 from bottom to top on the
left set of ports
• 24 through 47 from bottom to top on the
right set of ports.
• 0-7, 8-15, 16-23, 24-31, 32-39, and 40-47
FC8-64 port
blade • 0 through 31 from bottom to top on the
left set of ports.
• 32 through 63 from bottom to top on the
right set of ports.
• 0-7, 8-15, 16-23, 24-31, 32-39, 40-47, 48-55,
and 56-63*.
(* - Octet 56-63 E_Port trunks are permitted
on the logical or base switch only.)
FC16-32 port
blade • 0 through 15 from bottom to top on the
left set of ports.
• 16 through 31 from bottom to top on the
right set of ports.
• 0-7, 8-15, 16-23, and 24-31.
FC16-48 port
blade • 0 through 23 from bottom to top on the
left set of ports.
• 24 through 47 from bottom to top on the
right set of ports.
• 0-7, 8-15, 16-23, 24-31, 32-39, and 40-47.
FC16-64 port
blade • 0 through 63 from bottom to top.
These are QSFP ports 0-15. For
supported QSFPs, refer to
Qualified
transceivers for the FC16-64 port blade
and the core blades
on page 42
• 0-7, 8-15, 16-23, 24-31, 32-39, 40-47, 48-55,
and 56-63.
FCOE10-24
blade • 0 through 23 in two vertical rows from
bottom left to top right.
• NA
CR16-8 core
blade ICL connectors are numbered from:
• 0 through 7 from bottom to top on the left
set of ports.
• 8 through 15 from bottom to top on the
right set of ports.
Each connector is a group of four 16-Gbps
ports. For supported QSFPs, refer to
Qualified transceivers for the FC16-64 port
blade and the core blades
on page 42
• Trunk group 0: QSFP ports 0-3 and 8-11.
• Trunk group 1: QSFP ports 4-7 and 12-15.
NOTE
Individual FC ports within the same QSFP port
cannot form a trunk. A trunk has to comprise of
individual FC ports from different QSFP ports.
FS8-18 blade • The 16 physical Fibre Channel ports on
this blade are numbered 0 through 15
from bottom to top .
• The two 10/100/1000 BaseT ports are
numbered from the bottom as GE0 and
GE1.
• 0-7 and 8-15
Installation of the Brocade DCX 8510-8
28 Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-07