Brocade DCX 8510-8 Backbone Hardware Reference Manual - Manual (Page 94)

FIGURE 25 Power supply identification
1. Power supply 1 (PS1)
2. Power supply 2 (PS2)
3. Power supply 3 (PS3)
4. Power supply 4 (PS4)
Removing a power supply
To remove a power supply, complete the following steps.
1. Perform the appropriate following action based on whether the Brocade DCX 8510-8 is operating:
• If the Brocade DCX 8510-8 is not operating during the replacement procedure, go to step 2.
• If the Brocade DCX 8510-8 is operating and will continue to operate during the replacement,
check the power LEDs to verify that the minimum number of power supplies is functioning. Refer
to
Providing power to the Brocade DCX 8510-8 Backbone on page 27 to check your power
requirements.
2. Turn off the power switch.
3. Unlatch the power cord retainer clip.
4. Remove the power cord.
5. Loosen the thumbscrew.
6. Grasp the handle and pull, sliding the power supply from the chassis and supporting the power
supply from beneath as you remove it.
Removing a power supply
94 Brocade DCX 8510-8 Backbone Hardware Reference Manual
53-1002180-07