Site preparation – Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) User Manual

Page 10

Advertising
background image

Site preparation

1

2

Brocade Mobility 7131 Installation Guide - Dependent Mode

53-1001567-04

•

Connect all power cords to a properly wired and grounded electrical circuit.

•

Verify that the electrical circuits have appropriate overload protection.

•

Attach only approved power cords to the device.

•

Verify that the power connector and socket are accessible at all times during
the operation of the equipment.

•

Do not work with power circuits in dimly lit spaces.

•

Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.

•

Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.

•

Before installing or handling the

Mobility 7131

, have on hand an ESD wrist strap or

other ESD voltage limiting device.

CAUTION

For safety reasons, the ESD wrist strap should contain a 1 meg ohm series
resistor.

Site preparation

•

Consult your site survey and network analysis reports to determine specific
equipment placement, power drops, and so on.

•

Assign installation responsibility to the appropriate personnel.

•

Identify and document where all installed components are located.

•

Provide a sufficient number of power drops for your equipment.

•

Ensure adequate, dust-free ventilation to all installed equipment.

•

Identify and prepare Ethernet and console port connections.

•

Verify that cable lengths are within the maximum allowable distances for
optimal signal transmission.

Advertising