Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) - Manual (Page 29)

Brocade Mobility 7131 Installation Guide - Dependent Mode 21
53-1001567-04
Chapter
3
Basic Mobility 7131 Configuration
For the basic setup described in this guide, the Java-based Web UI will be used to
configure the Mobility 7131. To access the Mobility 7131 through the GE1/POE
port, the GE1/POE port default setting is DHCP client. For this example, the Mobility
7131’s WAN interface will be used to connect to the access point. The default WAN
IP address is 10.1.1.1. For optimal viewing of the Mobility 7131 Web UI, the screen
resolution should be set to 1024 x 768 pixels or greater.
NOTE
For advanced configuration options beyond the scope of this guide, refer to the
Mobility 7131 Product Reference Guide. The guide is available on the Brocade Web
site, at
http://www.brocade.com/support/ .
1. Start a browser and enter the following IP address in the address field:
https://10.1.1.1
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher (available
from Sun’s Website), and be sure to disable Microsoft’s Java Virtual Machine if
installed.
NOTE
The computer being used should be configured to use the same IP address and
subnet mask as the Mobility 7131.