Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) User Manual
Page 24
Mounting the Mobility 7131
2
16
Brocade Mobility 7131 Installation Guide - Dependent Mode
53-1001567-04
CAUTION
Brocade recommends care be taken not to damage the finished
surface of the ceiling tile when creating the light pipe hole and
installing the light pipe.
7. Remove the light pipe’s rubber stopper (from the Mobility 7131) before
installing the light pipe.
8. Connect the light pipe to the bottom of the Mobility 7131. Align the tabs and
rotate approximately 90 degrees. Do not over tighten
.
9. Fit the light pipe into hole in the tile from its unfinished side.
10. Place the decal on the back of the badge and slide the badge onto the light
pipe from the finished side of the tile.
11. Attach the antennas to their correct connectors.
For information on the antennas available to the Mobility 7131, see
CAUTION
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the Mobility 7131.