Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 535)

Brocade Network Advisor IP User Manual 481
53-1002947-01
Port profiles
16
Port profile configuration using the management application
You can manage MAC addresses and port profiles from the Port Profiles tab of the Fabric_Name
Properties dialog box, as shown in
Figure 167 .
FIGURE 167 Fabric_Name Properties dialog box — Port Profile tab
Deleting a port profile An in-use error is generated if the port profile is in an activated state. AMPP forces you
to de-activate the profile before deleting.
If the port profile is in an inactive state, then deletion of the port profile removes all
the MAC address associations as well.
Modifying port profile
content when in an
associated state An in-use error is generated if the port profile is already activated.
Moving the VM MAC
address and notifying
the fabric All policies associated with the port profile ID are mapped on the MAC address and
applied to the new port in the fabric.
Unused port profile You must manually remove the MAC address mapping to remove any MAC address
association.
TABLE 60 AMPP behavior and failure descriptions (Continued)
AMPP event Applicable behavior and failures