Brocade Network Advisor IP User Manual v12.1.0 - Manual (Page 703)

Brocade Network Advisor IP User Manual 649
53-1002947-01
Layer 3 access control list policy
20
14. Click OK on the Advanced Settings dialog box.
To finish configuring the ACL, return to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an extended L3 ACL configuration” on page 635
• “Copying an extended L3 ACL configuration” on page 636
• “Creating an IPv6 L3 ACL configuration” on page 637
• “Editing an IPv6 L3 ACL configuration” on page 639
• “Copying an IPv6 L3 ACL configuration” on page 640
Network configuration
The Management application allows you to filter traffic from a specific Network. A Network is made
up of one or more devices in a subnet. Use the following procedures to configure a network:
• “Viewing existing networks” on page 649
• “Creating a network” on page 650
• “Editing a network” on page 651
• “Copying a network” on page 652
• “Deleting a network” on page 652
Viewing existing networks
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 628
• “Editing a standard L3 ACL configuration” on page 630
• “Copying a standard L3 ACL configuration” on page 631
• “Creating an extended L3 ACL configuration” on page 632
• “Editing an extended L3 ACL configuration” on page 635
• “Copying an extended L3 ACL configuration” on page 636
To view all existing networks, complete the following steps.