Lincoln Electric IM635 RED-D-ARC GX 271Chopper LPG - Manual (Page 31)

GX 271 Chopper LPG
C-5 C-5 ACCESSORIES - CONNECTION DIAGRAMS
CAUTION :
or service this equipment.
Keep away from moving parts.
Keep guards in place.
ELECTRODE TO WORK
TO WORK
CABLE PLUG
K592 CONTROL CABLE
TO LN-742 INPUT
TO WIRE FEED UNIT
ELECTRODE CABLE
AMPHENOL
14 PIN
N.D. PLACE WELDER TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.
N.C. PLACE THE MODE SWITCH IN THE " WIRE WELDING-CV" POSITION.
THE ENGINE WELDER OPERATING MANUAL.
before servicing.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER VOLTMETER SWITCH TO
MATCH THE POLARITY OF THE ELECTRODE CABLE.
Do not touch electrically live parts.
Do not operate with panels open.
WARNING
Disconnect NEGATIVE (-) BATTERY LEAD
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
Only qualified personnel should install,use
GX-271 / LN-742 CONNECTION DIAGRAM
A
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
S24095-5
N.E. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED, PLACE OUTPUT CONTROL SWITCH IN "OUTPUT CONTROL REMOTE" POSITIION.
APPLICATIONS. SEE OPERATING MANUAL.
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
Disconnect NEGATIVE (-) BATTERY LEAD
Do not touch electrically live parts.
14 PIN
AMPHENOL
- +
before servicing.
Do not operate with panels open.
TO WORK
CAUTION :
THE ENGINE WELDER OPERATING MANUAL.
N.D. PLACE IDLER SWITCH IN "HIGH" POSITION.
APPLICATIONS. SEE OPERATING MANUAL.
Keep guards in place.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER VOLTMETER SWITCH TO
MATCH THE POLARITY OF THE ELECTRODE CABLE.
Keep away from moving parts.
WARNING
Only qualified personnel should install,use
or service this equipment.
TO LN-8 INPUT
K595 CONTROL CABLE
CABLE PLUG
S24095-6
N.C. PLACE THE MODE SWITCH IN THE "WIRE WELDING-CV" POSITION. PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE
GX-271 / LN-8 CONNECTION DIAGRAM
ELECTRODE CABLE TO WIRE FEED UNIT
A