Lincoln Electric IM635 RED-D-ARC GX 271Chopper LPG - Manual (Page 33)

GX 271 Chopper LPG
C-7 C-7 ACCESSORIES - CONNECTION DIAGRAMS
A
S24095-9
ELECTRODE
DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE
THE ENGINE WELDER OPERATING MANUAL.
N.C. PLACE THE MODE SWITCH IN THE "STICK/WELD" POSITION.
N.E. PLACE OUTPUT CONTROL SWITCH IN "REMOTE CONTROL" POSITION.
N.D. PLACE WELDER TERMINALS SWITCH TO " REMOTELY CONTROLLED" POSITION.
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY.
FLOWMETER
before servicing.
Do not touch electrically live parts.
REGULATOR
TO GAS
INPUT
FITTING
ARGON GAS
K936-1
CONTROL CABLE
CYLINDER
CAUTION :
Keep guards in place.
Keep away from moving parts.
WARNING
14 PIN
AMPHENOL
Only qualified personnel should install,use
or service this equipment.
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
TO WORK
K870 FOOT AMPTROL
-OR-
K963-1 HAND AMPTROL
-OR-
K814 ARC START SWITCH
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
GX-271 / K930 TIG MODULE / CONNECTION DIAGRAM
GX271