LumaSense Technologies IS 6 Advanced - Manual (Page 29)

IS 6 Advanced / IGA 6 Advanced Manual Controls and Installation · 29
Len indicates the length of the answered data string, incl. Carriage Return (Chr(13)).
In the lower part of the window, the connection with the preset baud rate can be checked. Here
the command was sent 100 times with 19200 baud. It has taken 0.997 seconds without
transmission errors.
Emi: AutoFind: If the true temperature of the measured object is known, you can calculate the
emissivity of the measured object using the Emi: AutoFind function:
A measured temperature is displayed with the
current set emissivity (in this example 100%)
(here: 619.8 °C).
If you press Emi: Autofind a window will open
which allows you to enter the "true" temperature
(here 650 °C).
Once the temperature entry has been entered and
confirmed with Calculate, InfraWin will then
calculate the emissivity which occurs with the new
temperature (here 59.0%). This is displayed
immediately and can be used for further
temperature measurement.
5.5 Measurement online trend
The measurement function
allows you to access a number
of input tabs located on the left side of the
screen. The main or home tab is the Output
Screen. You can toggle the input tabs on and
off by clicking them. This window displays:
· temperature as graphical diagram
· internal temperature of the instrument
· current temperature
· quantity of the measured values and
file size of the current measurement
The example shows a sample reading over the period of approximately 15 seconds with a
temperature range between 400 and 800 °C. The final temperature (at the end of the reading) is
431 °C.
The Mark Zone button allows you to color mark a temperature range for easier recognition.
The Threshold button allows you to set a temperature value as a baseline to prevent recording
values above or below the baseline temperature. This allows you to keep the output file size
small.
The Scaling Trend button allows you to scale temperature trend view.