LumaSense Technologies IS 6 Advanced - Manual (Page 9)

IS 6 Advanced / IGA 6 Advanced Manual Introduction · 9
2 Introduction
2.1 Appropriate use
The IMPAC IS 6 Advanced / IGA 6 Advanced are short wave infrared temperature measuring
devices with digital signal processing. They are used for non-contact temperature measurements
on metals, ceramics, graphite, etc. with a temperature range between 250 and 3000 °C.
2.2 Scope of delivery
Pyrometer, PC adjustment, and evaluation software InfraWin, works certificate, and operating
instructions.
Note: A connection cable is not included with the instrument and has to be ordered
separately (see Chapter
8 , Reference numbers).
2.3 Technical Data
Measurement
Temperature Ranges:
250 to 2500 °C (MB 25), IGA
250 to 1800 °C (MB 18), IGA
600 to 3000 °C (MB 30), IS
600 to 1800 °C (MB 18), IS
Sub Range: Any range adjustable within the temperature range, minimum span
50 °C
Spectral Ranges: IS: 0.7 to 1.1 µm
IGA: 1.45 to 1.8 µm
Resolution: 0.1 °C or 0.2 °F at interface; < 0.0015% of adjusted temperature range
at analog output, 16 bit; 1 °C or 1 °F on display
Emissivity
e
: 0.050 to 1.000 in steps of 1/1000
Transmittance
t
: 0.050 to 1.000 in steps of 1/1000
Response Time t
90
: 120 microseconds (for IGA 6, it is recommended for measuring
temperatures below 300 °C to set a response time of 1 ms (min);
adjustable to min; 1 ms; 3 ms; 5 ms; 10 ms; 50 ms; 250 ms; 1 s; 3 s; 10 s
Measurement Uncertainty:
(
e
= 1, t
90
= 1 s, T
Umg .
= 25 °C)
< 1500 °C: 0.3% of reading in °C + 2 °C
> 1500 °C: 0.6% of reading in °C
Repeatability:
(
e
= 1, t
90
= 1 s, T
Umg .
= 25 °C)
0.15% of reading in °C + 1 °C
Optics
Sighting:
Built-in laser aiming light (max. power level < 1 mW, λ = 630 to 680 nm,
CDRH class II) or through-lens sighting
Optics: Manually focusable from rear cover measuring distance
a = 210 to 5000 mm
Distance Ratio: IGA: approx. 350 : 1
IS: approx. 350 : 1