Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 148)

Survey Pro Reference Manual
R-140
Corner & Angle
Survey Corner & Angle .
The Corner and Angle screen is used to store a point that cannot be
shot on a reference line using a reflectorless total station where two
other points on the same line can be shot.
Foresight: is the name of the point that will be
stored.
Description: is the description for the point
that will be stored.
HR: 0.000: shows that no rod height will be
used with this routine since all shots are direct
reflectorless.
Shoot Line : will prompt you to take two shots
on a line that intersects with the point you
want to store.
Note: Each shot can be in any location on the line.
(Shot 1 can be to the left or right of Shot 2.)
Aim at Corner : will prompt you to aim at the corner
(the point that you want to store). Although no shot is
taken, the angles to the point will be used to compute
its location.
Note: After all shots are done, the computed elevation
is displayed for the new point. You can either enter a
different elevation or tap to accept the computed
elevation.
Backsight : opens the Backsight Setup screen (Page R-118) where the
current backsight can be modified.
Line
Aim at target
(no shot)
Shot 1
Shot 2
Corner & Angle