Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 178)

Survey Pro Reference Manual
R-170
GeoLock Settings
Survey Remote Control Settings
or Job Settings GeoLock .
The GeoLock Settings screen is used to enable/disable GeoLock and
configure the receiver communication settings.
Enable GeoLock: When checked, enables the
GeoLock feature.
Model: Only Generic NMEA can be selected,
which works for most GPS receivers that
output NMEA data.
Serial Port: is the serial port on the data
collector used to communicate with the GPS
receiver.
Bluetooth… : (Available only when using a
Bluetooth GPS receiver and Bluetooth is
selected for the Serial Port.) accesses the Bluetooth configuration
screen that comes with the Bluetooth driver software where you can
quickly check or change the virtual COM port and favorites. See the
User’s Manual for more information on configuring Bluetooth.
Baud Rate: is the speed that communication takes place. This must
match the baud rate set in the GPS receiver.
Parity: This must match the parity set in the GPS receiver – usually
None.
Use 3D GeoLock…: When checked, the GPS elevation will also be
used to compute your location and adjust the vertical angle of the
total station accordingly. GPS is generally less precise vertically than
horizontally so unless you are using GeoLock while in very steep
terrain, this item should remain unchecked.