Spectra Precision Survey Pro v4.5 Ranger Reference Manual - Manual (Page 88)

Survey Pro Reference Manual
R-80
Raw Data Note
Enter any note to append to the raw data file.
You can use the buttons to insert common line
work commands.
When finished, tap Write Now! to append the
note to the end of the raw data file.
View DTM
Job View DTM .
Before viewing a DTM, the Setup DTM 3D screen will open where the
DTM layers must be defined. This screen is also used to define other
parameters for the DTM.
Layers : opens the Layers for Staking DTM
screen where the DTM layers are selected.
Boundary : opens the Choose Polyline screen
where a polyline can be selected that defines
the boundary of the DTM.
Exclude points…: will move any points that
exist outside the selected boundary to the
Auxiliary layer. If a point is later stored
outside the boundary, they will also be moved
to the Auxiliary layer.
Discard the boundary…: will initially move any points that exist
outside the boundary to the Auxiliary layer. If a point is later stored
outside the boundary, the selected boundary is automatically
unselected.
Clear : will unselect the selected boundary and move it to the
Auxiliary layer.