Triton ARGO User Manual - Manual (Page 22)

18
I
NTRODUCTION
D
ISPENSING
M
ECHANISMS
ARGO U
SER
M
ANUAL
Currency capacity depends upon the dispenser mechanism installed in the ATM, but is also affected by note
quality and thickness. Typical capacities are provided in the following table: DO NOT be tempted to over
fi ll the cassette.
The purpose of this section of the manual is to describe the procedures for cassette closing and replenishment.
Information concerning note handling and quality issues are explained where appropriate.
The dispensing mechanism delivers the appropriate number of notes from the note cassette to fulfi ll the
customer’s withdrawal request. The purpose of the reject area or cassette is to accept and hold notes that have
been transferred from the note cassette but not dispensed. Some situations that could cause the mechanism to
reject notes are:
(1) Multiple notes stuck together (2) Note width too short or long.
Other conditions that could cause a reject are described in the following section, N
OTE
C
ONDITION
.
**CAUTION**
DO NOT RECYCLE REJECTED NOTES INTO A CASSETTE!
DOING SO COULD CAUSE MORE REJECTS AND/OR CURRENCY JAMS.
* PLEASE READ *
The ARGO Model RL1713 production units are equipped with the MiniMech dispenser and have the
shallow cabinet design.
The ARGO Model RL27XY (7 inch screen) and the ARGO Model RL63XY (12.1 inch screen) are equipped
with one of the following dipsenser types: SCDU, HCDU, SDD, TDM250, or NMD50. These models have
the deep cabinet design.
DISPENSER CASSETTE RECOMMENDED
MAXIMUM CAPACITY
REJECTED NOTE
CAPACITY
MiniMech Single 750-1000 Notes Less than 100
SDD Single 1700-1800 Notes Less than 100
SCDU Single 1000 Notes Less than 100
HCDU Dual 3500 Notes (1750 each) Less than 100
TDM250 Dual 2600 Notes (1300 each) Less than 100
NMD50 Dual 3500-4000 (1750-2000 each) Less than 100
ARGO DISPENSING MECHANISM