Triton ARGO User Manual - Manual (Page 25)

ARGO U
SER
M
ANUAL
21
1. Pull the packer plate to the rear of the tray (toward the handle). Ensure the packer plate is fully back.
Maintain pressure on the packer plate as needed while loading notes.
2. Count the number of bills that remain in the
cassette, if any. Next, count the number of bills
that are being added into the cassette.
3. Add the number of bills being placed into the
cassette to the number that remained. The total
number of these bills will be entered in the Enter
Cassette Quantity option (shown in step 6 of
C
ASSETTE
C
LOSE
P
ROCEDURES
on previous page).
4. Place the currency into the cassette. Allow at least
one inch of clearance between the packer plate
when it is fully retracted and the currency. This will
allow the packer plate to compress the currency.
Do not try to over fi ll.
SCDU/HCDU
Pull packer plate back before loading notes.
Loading the Note Cassette
Note: You may wish to record the number of notes removed from the reject compartment
for use when balancing the note tray against the cassette/day close records.
1. Unlock and open the security cabinet door.
2. Remove any rejected notes. The reject compartment is located above the cassette.
3. To remove the note tray, grasp the tray handle, lift slightly, and slide the tray out of the mechanism. Place
the note tray on a fl at level surface. Use the security key to unlock the cassette, and open the lid.
Removing note tray from the dispensing
mechanism.
Removing rejected notes.
R
EPLENISH
C
ASSETTE
P
ROCEDURES