Triton 9200 Operation Manual - Manual (Page 117)

5-81
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
T
RITON
S
YSTEMS
, I
NC
.
M ODEL 9200 S UPER S CRIP TM O PERATION M ANUAL
F
UNCTION
: PRIMARY NUMBER
F
ACTORY
D
EFAULT
: NONE
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select TELEPHONE.
4.) Select the PRIMARY NUMBER option.
D
ESCRIPTION
:
The Terminal communicates to your host processor over a dial up phone line. The phone number
of the processor must be entered before live transactions can be performed.
When this function is selected, the current phone number is displayed (if nothing appears on the
screen, no number is set). Select CHANGE to blank the current entry, and then enter the desired
phone number. The phone number may be up to 30 digits long. It can also contain a dialing prefix,
such as a ‘9’ for an outside line, if necessary. If you need to pause after the prefix, place a comma
in the number for a two-second delay at that point. Pressing the <BLUE> key first, then the <0>
key, followed by the <RIGHT ARROW> key will select the comma character. Make sure to enter
the long distance prefix ‘1’ if you are dialing an 800 number or a toll long distance number. Do not
enter dashes in the number.
E
RROR
C
ONDITIONS
:
The Terminal will not process transactions if the phone number has not been entered or has been
entered incorrectly. In such cases error code “185 - Phone Number Not Configured”, will be
received.