Triton 9200 Operation Manual - Manual (Page 26)

3-8
T
RITON
S
YSTEMS
, I
NC
.
S
ECTION
3 - O
PERATION AND
S
ETUP
M ODEL 9200 S UPER S CRIP TM O PERATION M ANUAL
•
PIN Master/Working Keys
The PIN MASTER KEY is used to decrypt the PIN WORKING KEY. The Pin MASTER
KEY was referred to as the MASTER KEY in previous versions of ATM operating software.
The PIN WORKING KEY was referred to as the COMMUNICATIONS (COMMS) KEY.
Each key is a 16-character string, consisting of a combination of the digits 0-9 and the letters
A-F. The PIN MASTER KEY may be entered manually, or may be injected from a personal
computer, using a special floppy disk. The PIN WORKING KEY may be entered manually
or downloaded from the processor.
A
DDITIONAL
S
ETUP
P
ARAMETERS
In addition to the configuration parameters described in the previous paragraphs, there are several
other parameters that will need to be entered into the Terminal to complete its setup. The proce-
dures for setting each of these parameters are found in Section 5 of this manual. Some parameters
are processor-specific and may not be available for all locations.
•
Maximum Amount
The maximum withdrawal limit must be entered into the Terminal before any transactions can
be completed. This number is the largest dollar amount allowed for a single withdrawal trans-
action. The MAXIMUM AMOUNT may be set from $1 to $999 in increments of $1 and must
be set to a multiple of the denomination of the currency in the cassette. Factory default is set to
$500.00. The value must be a whole dollar amount only.
Whenever a withdrawal transaction is processed, the amount entered or selected is compared to
the MAXIMUM AMOUNT parameter. If the entry is larger, an error message warns the user
and displays the maximum allowable amount. Additionally, the MAXIMUM AMOUNT cannot
be more than 50 times greater than the denomination of the currency in the cassette.
The MAXIMUM AMOUNT entered into the Terminal DOES NOT override any maximum
set by a network. The transaction will be sent to the network if the amount entered or selected
is less than the maximum. The network must still approve the requested amount.
•
Store Message
The Store Message consists of up to four lines of text that are printed at the top of each receipt
and report. This message is typically used to print the store name, address and phone number.