Triton 9200 Operation Manual - Manual (Page 23)

3-5
T
RITON
S
YSTEMS
,
I NC .
S
ECTION
3 - O
PERATION AND
S
ETUP
M
ODEL
9200 S
UPER
S
CRIP TM O
PERATION
M
ANUAL
The <RIGHT ARROW> and <LEFT ARROW> keys are used in most alphanumeric data entry
situations. The <LEFT ARROW> is used to back up and erase a character. The <RIGHT ARROW>
is used to lock in a character. These keys will auto-repeat if held down for more than one second.
The <CHANGE> key can be used to clear an entry and start over. The <CANCEL> key will abort
the current transaction.
The keys located beside the display are called the Screen Keys. They are used in the selection of
menu functions. A Screen Key is only active when a function or menu option name is displayed
beside the key.
C
HANGING
T
O
M
ANAGEMENT
F
UNCTIONS
You can enter the terminal MANAGEMENT FUNCTIONS main menu screen by performing any
one of the three procedures listed below:
1. The Customer Welcome screen shows an animation of a hand inserting and removing a
card, with a message describing how to begin a transaction. If this screen is being dis-
played, press and hold down the <BLUE> key; while holding down the <BLUE> key,
press the <1> key. Release both keys. After a moment the Top Menu screen (shown in
Figure 3-1) will be displayed. Select the MANAGEMENT FUNCTIONS option.
2. Reset the Terminal by pressing and releasing the Reset Switch found on the front panel of
the Memory Module, which is located in the card cage inside the upper enclosure of the
terminal. When the Top Menu is displayed select MANAGEMENT FUNCTIONS.
3. Remove and then reapply power to the terminal using the ON/OFF switch located on the
right side of the card cage inside the upper enclosure of the terminal. When the Top Menu
is displayed select MANAGEMENT FUNCTIONS.
The Top Menu allows you to choose one of two options, CUSTOMER TRANSACTIONS or
MANAGEMENT FUNCTIONS. Selecting CUSTOMER TRANSACTIONS changes the display
to the Customer Welcome screen so the Terminal is ready to perform customer transactions. Se-
lecting MANAGEMENT FUNCTIONS opens the password screen, which in turn provides access
to menus that are used for changing or viewing terminal parameters.
Whenever the MANAGEMENT FUNCTIONS choice is selected, the Terminal will ask for a pass-
word to be entered. For a first-time configuration, enter the default MASTER PASSWORD of
’123456’ on the keypad and then press the <OK> key. This ‘default’ password will be valid until