Triton 9200 Operation Manual - Manual (Page 164)

S
ECTION
8 - E
RROR
R
ECOVERY
8-2
T
RITON
S
YSTEMS
, I
NC
.
M ODEL 9200 S UPER S CRIP TM O PERATION M ANUAL
I
NTRODUCTION
The SuperScrip Terminal operating system determines the operational status of each of its compo-
nents by routinely performing a system status check. A status check is performed:
1.) During power up.
2.) Once every forty seconds while the Terminal is not in use.
3.) Before leaving the Management Functions main menu screen.
4.) After every transaction.
An error detected during a status check will place the Terminal in an “OUT OF SERVICE” mode
of operation and display the messages shown in Figure 8-1 on the LCD display screen.
E
RROR
R
ECOVERY
Many error conditions require the assistance of a qualified service technician to return the SuperScrip
Terminal to normal operation. But there are some actions that the end user can perform to confirm
the existence of a problem or correct simple problems.
Table 8-1, Error Recovery Procedures, provides a list of error conditions that can cause the SuperScrip
Terminal to enter an “OUT OF SERVICE” condition. The table lists the error codes, a description
of each error message and possible corrective actions non-service personnel can perform in an
attempt to return the unit to normal operation.
Many of the procedures direct you to RESET the SuperScrip Terminal as the first step. This action
may be all that is necessary to clear the error indication. In other cases further actions may be
necessary. If necessary, you will be directed to contact your service organization.
Figure 8-1. The “Out of Service“ display.