Triton FT7000XP Installation Manual - Manual (Page 26)

26
FT7000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
It’s recommended that the unit be secured to the facility floor. The footprint of the cabinet floor allows for
securing the unit through the leveling feet “plinth” hardware, regardless of how high the unit may be
raised. It is the customer or their agent’s responsibility to determine how/where the unit is affixed to the
facility. Listed are some general considerations when securing the unit:

What is the floor structure (concrete, wood, etc)? Is the unit a UL Level 1 safe cabinet or Business
Hours? Will the floor support the weight of the cabinet?
     Is the inside floor the same level as the outside ground? Will the unit need to be raised/lowered using
the cabinet leveling feet (mounted to the unit’s plinth)? Leveling feet compensate for differences
between inside floor and outside ground.
Level 1 Cabinet Safety
Level 1 cabinets are considerably
heavier than Business Hours cabi-
nets! Exercise extreme caution when
moving Level 1 cabinets! At least
two persons should work together
to move the cabinet into position
for mounting!
Tool Use / Safety
Observe ALL safety precautions
for operating hand and power
tools! Wear eye and ear protec-
tion while operating the electric
drill!
USE A BACK-SUPPORT BELT
WHEN LIFTING AND MOVING
THE ATM!
B
EFORE
Y
OU
S
TART
 If installing a FT7000 XP where a previous ATM was installed, verify that the wall opening is consistent
with the dimensions and height requirements listed in this manual. Modifications to the wall or floor
may be required.

Is exterior wall solid (brick, concrete)? Wood framed? Aluminum siding? Do you need to insulate the
wall cavity?
 After cabinet is anchored, is the control panel collar hardware flush against the exterior wall? Is this
trim hardware sufficiently sealed to prevent moisture from entering the control panel electronics?
    
Ensure that doorways and corridors leading to the point of installation are wide enough to allow the
shipping package to pass through. If access is restricted, make arrangements to unpack the unit in an
area with sufficient space and move it to the installation site.