Triton FT7000XP Installation Manual - Manual (Page 43)

43
FT7000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
S
TEP
7:
I
NSTALLING
/ S
ECURING
C
ONTROL
P
ANEL
C
OLLAR

(Outside facility - Control panel extended / open). Locate the control panel collar assembly.
Align the trim tabs located on back of assembly (2 - each side) with the slotted openings of the control panel.
Insert tabs and push down slightly.

(Top of control panel) Loosen thumbscrew and remove enclosure lid shown to gain access to
control panel GPIO docking board.

Connect the wires from the collar assembly to the connector shown. Reinstall the enclosure lid.
    
(Inside control panel) Secure the collar assembly with eight (8) screws provided. Figure below
shows location of screw holes.
    
    
    
    
C
ONTROL PANEL COLLAR