Triton FT7000XP Installation Manual - Manual (Page 42)

42
S
TEP
6: S
ECURING
C
OLLAR
B
RACKETS
:

(Inside facility) Open the upper right side rear cabinet door. Unlock and pull the green handle
shown. This will release the control panel latch.

(Outside facility) Grasp the control panel on both sides and slowly pull it out to its full extension
(the left side will lock in place).
    
    

Slowly swing the front control panel open to its full extension (the green tipped, spring-loaded
drop pin will fall into place, locking further lateral movement).

Reinstall the collar brackets (refer to S
TEP
2, P
G
. 39). Secure all nuts to the cabinet tube. Next,
secure brackets together with four (4) nuts provided.
    
    
Note: If there are uneven gaps between brackets and wall, this can now be adjusted with the unit’s
leveling feet. If adjustments are required, check to ensure unit is as close to level as possible.
S
ITE
P
REPARATION
/ I
NSTALLATION