Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 - Manual (Page 101)

Chapter 2 Operation
93
No. Item Details
DispMode selectors These are used to select either the GUI display mode or the binary display
mode.
GUI display mode
For the block types supported by this mode, the data is displayed on a
screen that allows for easy graphical readout. For block types which are
not supported, the data is displayed in the binary mode.
Binary display mode
The data is displayed in a 128-byte binary format.
Toolbar Open: Click this to open the DDC data.
Save: Click this to save the DDC data in a file and overwrite any existing
data in that file in the process.
Save As: Click this to save the DDC data in a new file.
Send: Click this to send the DDC data which is being edited to the
monitor.
Receive: Click this to receive the DDC data from the monitor.
Verify: Click this to compare the DDC data being edited against the data
stored in the monitor's ROM.
Print: Click this to print the DDC data.
Comment: A comment for the DDC data can be entered here.
Block type list A list of the block types appears here. The block number and block type
(1-byte block code at the head) are displayed for each block.
Data display The data of the block selected on the block type list on the left is displayed
here.
Checksum The checksum value is displayed here.
The checksum is the value of the last byte of the block.
When "Auto checksum" is checked, the checksum value is automatically
updated each time the data is changed.
Automatic checksum
calculation ("Auto
checksum")
When this is checked, the checksum value is automatically updated each time
the data is changed.