Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 User Manual
Page 31
Chapter 2 Operation
23
Output condition data settings
Mode
ANALOG, Tri-Sync (1080) ,Tri-Sync (720) ,NTSC ,PAL ,SECAM is selected here.
HS
"NEGA," "POSI" or "OFF" is selected here as the HS polarity setting.
VS
"NEGA," "POSI" or "OFF" is selected here as the VS polarity setting.
CV
"OFF," "R," "G," "RG," "B," "RB," "GB" or "RGB" is selected here as the CV setting.
CS
"NEGA," "POSI" or "OFF" is selected here as the CS polarity setting.
VIDEO LEVEL
A voltage level from 0.3 to 1.0V is set here as the video level.
SET UP
A voltage level from 0 to 0.25V is set here as the setup level.
SYNC LEVEL
A voltage level from 0 to 0.06V is set here as the sync level.
PbPr No.
A number from 0 to 9 is set here as the color difference table number.
RGB/Y,B-Y,R-Y
Either "RGB" or "Y,B-Y,R-Y" is set here as the color difference setting.
DVI Mode
Either "Single" or "Dual" is selected here as the DVI output setting.
D Conector(Line1)
"480," "720" or "1080" is selected here as the Line1 setting.
D Conector(Line2)
"Interlace" or "Progress(ive)" is selected here as the Line2 setting.
D Conector(Line3)
"4:3," "4:3LB" or "16:9" is selected here as the Line3 setting.
S Conector
"Normal," "Letter Box" or "Squeeze" is selected here as the S Connector output.
Analog(BNC)
"ON" or "OFF" is selected here as the Analog (BNC) setting.
Analog(D-SUB)
"ON" or "OFF" is selected here as the Analog (D-SUB) setting.
DVI(Digital)
"ON" or "OFF" is selected here as the DVI (Digital) setting.
DVI(Analog)
"ON" or "OFF" is selected here as the DVI (Analog) setting.
D Conect
"ON" or "OFF" is selected here as the D Connect setting.