Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 - Manual (Page 34)

CROSS: Crosshatch pattern
This button is used to set the crosshatch pattern.
The crosshatch pattern is always displayed after the screen center has been calculated. The screen center can be
calculated when the number of display dots and number of display lines are odd numbers. However, when they are
even numbers, the actual screen center will be one dot to the right and one line below the center. An error results when
0 is set for both H and V.
Mode Specification as a number of lines (line) or dot intervals (dot) is selected here as
the mode setting.
Format The save start point (From Center or From Top Left) is selected here.
Interval The number of lines (when "line" has been selected) or the dot interval (when
"dot" has been selected) of the crosshatch pattern is set here.
Width The width of the drawn lines is set here.
26