GW Instek PSU-Series Programming User Manual - Manual (Page 80)

PSU Programming Manual
80
Parameter OFF | 0 Turns the OCP off.
ON | 1 Turns the OCP on.
Return parameter <bool> Returns the over current protection state in
<bool> format.
Example SOUR:CURR:PROT:STAT OFF
Turns OCP off.
[:SOURce]:CURRent:PROTection:TRIPped
Set
Query
Description Returns the state of the current protection circuits.
Query Syntax [:SOURce]:CURRent:PROTection:TRIPped?
Return parameter <bool> Returns protection status.
Example SOUR:CURR:PROT:TRIP?
>0
The protection circuit has not been tripped.
[:SOURce]:CURRent:SLEW:RISing
Set
Query
Description Sets or queries the rising current slew rate. This is
only applicable for CC slew rate priority mode.
Syntax
Query Syntax [:SOURce]:CURRent:SLEW:RISing
{<NR2>(A)|MINimum|MAXimum}
[:SOURce]:CURRent:SLEW:RISing?
Parameter <NR2> Per step is Rated Current divided by 100 ms.
MIN Minimum rising current slew rate.
MAX Maximum rising current slew rate.
Return parameter <NR2> Returns the step current in amps.
Example SOUR:CURR:SLEW:RIS?
0.950
Sets the rising current slew rate to 0.950 A/ms.