GW Instek PSU-Series Programming User Manual - Manual (Page 88)

PSU Programming Manual
88
:SYSTem:CONFigure:BEEPer[:STATe]
Set
Query
Description Sets or queries the buzzer state on/off.
Syntax
Query Syntax :SYSTem:CONFigure:BEEPer[:STATe]
{<bool>|OFF|ON}
:SYSTem:CONFigure:BEEPer[:STATe]?
Parameter OFF | 0 Turns the buzzer off.
ON | 1 Turns the buzzer on.
Return parameter <bool> Returns the buzzer status.
:SYSTem:CONFigure:BLEeder[:STATe]
Set
Query
Description Sets or queries the status of the bleeder resistor.
Syntax
Query Syntax :SYSTem:CONFigure:BLEeder[:STATe]
{<bool>|OFF|ON}
:SYSTem:CONFigure:BLEeder[:STATe]?
Parameter OFF | 0 Turns the bleeder resistor off.
ON | 1 Turns the bleeder resistor on.
Return parameter <bool> Returns bleeder resistor status.
:SYSTem:CONFigure:CURRent:CONTrol
Set
Query
Description Sets or queries the CC control mode (local control
(panel), external voltage control, external
resistance control). This setting is applied only
after the unit is reset.
Syntax
Query Syntax :SYSTem:CONFigure:CURRent:CONTrol { <NR1> }
:SYSTem:CONFigure:CURRent:CONTrol?
Parameter/Return <NR1> Description
0 Local (Panel) control
1 External voltage control
2 External resistance control; 10kΩ = Io max,
0kΩ = Io min.