GW Instek APS-1102 User Manual - Manual (Page 29)

2.4 Simple Operation Checks
APS-1102 Programmable AC/DC Power Source 2-9
2. Panel settings
Set the APS-1102 as shown below. See “3.4 Main Operation Example”, for descriptors
of the settings methods.
Table 2-1. Panel Settings for Operation Check
Item Setting
Output mode AC-INT mode
Output voltage range 100 V
AC output voltage 100 Vrms
Selected measurement display RMS
3. Press the
OUTPUT
key to turn on output.
OUTPUT OUTPUT
Output is off. Output is on.
⇒ Check that the control panel MEASURE screen shows 100 Vrms as the AC output voltage.
Figure 2-3. Operation Check
⇒ If the normal values are not displayed, it may be due to an operation fault. Contact Good Will
or a Good Will representative.
4. Turn off the power, check that OUTPUT off is displayed, then press the power switch to the bottom
() position. This shuts off the power supply and turns off the power source unit.
Before turning off the power, make sure that the output on/off LED is off.
Output on/off LED is on.
Check display.
！
CAUTION