GW Instek APS-1102A User Manual - Manual (Page 149)

5 MENUS
APS-1102A 5-15
5.3 SET Menu
The SET menu in the menu window is used to set basic functions.
The available settings differ according to the output mode.
Table5-11. SET Menu Items and Output Modes
Item
Output Mode
AC AC+DC
INT EXT ADD SYNC INT EXT ADD SYNC
Selection of output mode
See “5.3.1 Output mode setting”.
       
Selection of output voltage range
See “5.3.2 Output voltage range
setting ”.
       
Setting of AC voltage to be output
See “5.3.3 Setting output
voltage ”.
     
Setting of AC voltage to be output
See “5.3.3 Setting output
voltage ”.
  
Setting of frequency to be output
See “5.3.4 Setting output
frequency
”.
   
Setting of phase when output is on
See “5.3.5 Output initial phase
settings ”.
     
Selection of waveform to be output
See “5.3.6 Waveform settings”.
     
Selection of external sync signal source
See “4.7 Synchronize the Output
with External Signal ”.
 
External input gain setting
See “4.9 Amplification of
External Signal ”.
   
Output peak current limit value (positive)
setting
See “5.3.7 Peak current limiter
settings ”.
       
Output peak current limit (negative) setting
See “5.3.7 Peak current limiter
settings ”.
       
Output RMS current limit value setting
See
“5.3.8 RMS current limiter
settings ”.
       
Use of other functions and detailed settings
See “Table5-4. Items in MISC
Menu ”.
       