Jenway 3510 - Manual (Page 27)

Interfacing (continued)
T he RS232 communications parameters on the computer or printer need to be set to match those of
the Model 3510, as detailed below:
1200 Baud 9600 Baud
7 Data Bits 8 data bits
Odd Parity OR No parity
1 Stop Bit 1 stop bit
Setting of these options is detailed in Section 3.6.6.
The Model 3510 supports both hardware (CTS/RTS) flow control and software XON/XOFF flow control.
Pressing the PRINT key outputs from the RS232 interface.
Sending an ASCII “D” to the 3510 causes a printout of the current displayed reading plus sample
number.
Sending an ASCII “C” causes a printout of the last calibration parameters.
Sending an ASCII "P" causes a printout of the stored readings.
6.3 Keypad Emulation
351 050/REV B/09-06 24
Keypad remote control using RS232 interface:
7 - Instrument On / Standby / Escape
1 - Calibrate / Memory Clear
9 - Print
8 - Up Arrow
2 - Down Arrow
4 - Left Arrow
6 - Right Arrow
3 or 5 - Enter / Store