Jenway 3510 User Manual
Page 5
351 050/REV B/09-06
2
Section 2
Installation
2.1 Unpacking
Remove the Model 3510 from the packaging and ensure the following items are included:
1. Model 3510 pH/mV/Temperature Meter
2. Glass bodied combination pH electrode (924 005)
3. ATC probe (027 500)
4. Electrode holder
5. 4, 7 and 10pH buffer sachets
6. BNC shorting plug (009 146)
7. Power Supply (as specified at time of ordering the product)
8. Condensed operating instructions (351 051)
9. Operating Manual (351 050)
Any shortages or damage should be reported immediately to the manufacturer or your local
distributor.
2.2 Installation
The Model 3510 is supplied ready to use. Connect the ATC (if required) and the pH electrode to the
rear panel Temp and pH sockets.
The electrode stand requires minimal assembly (refer to the diagram below).
Fig. 2.2.1 Electrode Holder Assembly
4
1
2
3