Jenway 3510 - Manual (Page 28)

25 351 050/REV B/09-06
6.4 Printing
A 32 column serial printer (037 701) is available for use with the Model 3510.
Connect the printer via the cable supplied with the printer to the 9 way socket located on the rear
panel of the instrument.
To intiate a print out of data press the print key.
When the first print is performed a header section will be printed showing:
Instrument name
Spacing for entry of Operator & User ID
Most recent calibration information
Eo value
Slope efficiency
Buffer type
This will be followed by results data in either pH or mV dependent on mode selected. Details will
also be given on temperature.
An asterisk (*) indicates that manual temperature compensation is being used.
A reading in the Relative mV mode will be indicated by an R.
Each reading will be numbered sequentially.
A calibration will reset the data number to 0001 and the header information will be re-printed.
To obtain a print out of stored readings, enter the RESULTS MODE and press the print key. A print
out of all 32 print locations will then be generated.