Viewing and deleting stored data – KANOMAX 6036 Multi-function thermal anemometer User Manual User Manual
Page 21
20
Data Storage and Statistical Calculation
Viewing and Deleting Stored Data
The average, maximum and minimum value of the stored data can
be viewed on the display and deleted.
Data viewing and deleting procedure will be described below by
taking an example of an operation in the “Air Velocity / Air
Temperature Measurement Mode”.
●
Viewing the Stored Data
Press the
key when the
instrument is in the measurement
mode in which the data is stored.
The most recently stored average
value (AVG) will be displayed.
●
Viewing Other Data
By pressing the
key, maximum,
minimum and average value of the
data group can viewed. To move to the
previous/next data group, press
keys.
●
Exit from Data Viewing
Press the
key to exit (cancel)
data viewing. When cancelled, the
screen will return to the measurement
mode.
●
Deleting the Stored Data Group
Select the data group to be deleted,
and press the
key. The air
velocity value will start blinking.
To delete the selected data, press the
key again. When pressed,
will be displayed. After displaying
, the screen will return to the
original measurement mode.
To delete ALL data groups stored in the
relevant measurement mode, press
and hold the key for approx. 5
seconds until
is displayed. All
Data Groups stored under this mode
will be cleared. After
is
displayed, the screen will return to
the measurement mode.
■
The function
of viewing and
deleting
stored data
is available on
MODEL6036