KANOMAX 6036 Multi-function thermal anemometer User Manual - Manual (Page 4)

iii
Danger
Never bring the probe close to a flammable gas atmosphere.
The heated sensor may cause a fire or explosion.
Never touch the sensor.
The sensor is heated during operation. Touching the heated sensor
may cause burns, and may also damage the sensor itself.
Do not disassemble or heat the batteries, or put them into a
fire.
This may cause burns and the batteries may burst.
If abnormal noises, smells or smoke occur, or if liquid enters
the instrument, turn off the instrument immediately, and
remove the batteries or pull out the plug.
There is possibility of malfunction, electric shock, and/or fire. Please
contact your local distributor or our service center for repair.
Caution
Always unplug the instrument from the electrical outlet when
the instrument is not in use.
Failure to do so may cause an electrical shock, fire or circuit damage.
Do not use the instrument in a water vapor atmosphere.
Condensed steam on the sensor will change the heat dissipation rate,
resulting in inaccurate measurements. It may also cause damage to
the sensor.
This instrument is designed to be used in an environment with
a clean air stream without any dust or foreign materials.
Foreign materials may cause damage to the sensor. Also dust or
foreign materials on the sensor will impede accurate measurements.
Do not apply force to the sensor.
If the sensor is deformed, the accuracy of the sensor may be
affected.
When measuring, ensure that the direction mark is facing into
the airflow.
Otherwise, the measurement may be inaccurate, as some sensors
(uni-directional probes) have a specific directivity.
Forbidden
Hot surface Don’t touch
Explosive Use properly
Forbidden
Set up properly
Caution
Use properly
Forbidden
Forbidden