KROHNE OPTISONIC 7300 EN - Manual (Page 65)

OPERATION
6
65
OPTISONIC 7300
www.krohne.com 09/2012 - 4001102303 - MA OPTISONIC 7300 R03 en
6.3 Function tables
6.3.1 Menu A, quick setup
INFORMATION!
• The following tables describe the functions of the standard device with HART ® connection.
The functions for Modbus, Foundation Fieldbus and Profibus are described in detail in the
corresponding supplementary instructions.
• Depending on the device version, not all functions are available.
No. No. No. No. Function Function Function Function Settings / descriptions Settings / descriptions Settings / descriptions Settings / descriptions
A1 language Select: English / Français / Deutsch
A2 tag
Measuring point identifier (Tag no.) (also for HART ® operation),
appears in the LCD display header (up to 8 digits).
A3 reset
A3.1 reset errors Reset? Select: no/yes
A3.2 counter 1 Reset counter? Select: no / yes (available if activated in C5.9.1)
A3.3 counter 2 Reset counter? Select: no / yes (available if activated in C5.9.2)
A3.4 counter 3 Reset counter? Select: no / yes (available if activated in C5.9.3)
A4 GDC IR interface This function requires an optical GDC adapter connected to the LCD
display. After 60 seconds without a connection being established or
after the adapter is removed, the function is exited and the optical
keys are active again.
Select: break (exit function without connection)
Activate (the IR interface adapter and interrupt the optical keys)