KROHNE CORIMASS G-MFM 4085 EN - Manual (Page 28)

28
4.3.1 How to enter programming mode
To start:
Display Comments
→
Press Fct. 1.0
Operation
or If this appears, see next box: ”Function of the keys ” .
CodE 1
---------
If this appears on the display, set the 9-keystroke Entry
CodE 1 .
Factory setting:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
1st- 8thplace
(key) CodE 1
∗∗∗∗∗∗∗∗
-
Each keystroke acknowledged by "
∗
" in display.
9th place
(key) Fct. 1.0
Operation If this appears, see box: ”Function of the keys ” below.
CodE 1
(9 alpha
characters) A wrong Entry CodE 1 was keyed in. Press any key and set
the correct 9-keystroke
4.3.2 How to terminate Programming mode
To terminate:
Press
↵
1-3
times
Fct (1).0
OPERATOR Press
↵
1-3 times until the cursor is under the extreme
left menu column. (Fct. 1.0 , 2.0 or 3.0)
↵
+ 12.345
kg/min
or If no changes have been made to the system’s configu-
ration return directly to the measurement mode.
(ACCEPT YES) Changes have been detected. Press
↵
to accept these
changes.
or
↑ (ACCEPT NO) Press
↵
to reject changes and return directly to
measurement mode.
or
↑
(GO BACK) Press
↵
to return to the menus, Fct. 1.(0) to make
further changes
↵
PARAM.CHECK Assuming ACCEPT YES was selected,
the system now checks the new setting for errors.
After 1-2 sec. + 12.345
kg/min No errors detected. Return to measurement mode.
or
Fct. (4).0
PARAM.ERROR Errors were detected. The sub-menus of 4.0 will guide
the operator to those functions where problems have
been identified.